does superior drummer 2.0 work with ableton live lite

The default install path for a Toontrack VST plug-in on 32-bit Windows is:.but it has been a long time since I really examined it and I've never touched the module's onboard sequencer after that.).The Default installation path on Windows as stated in the FAQ: (don't forget that there may be a volume setting in your module's onboard sequencer, which I believe will relate to MIDI output. I'd say look for ALL volume settings in your module and adjust them while noting any difference in output from your DAW.

There is also the possibility that your module or DAW has a MIDI Volume setting that is set low. and then everything in between).Īfter that, then I recommend you fine tune response using Superior 2.0 Velocity Controls

I recommend creating a new Trigger Bank in your module if supported, and without really listening to sounds, set the Sensitivity and response curves for each pad (So that when you hit hard, the meter in your module goes to 'Peak', and when you hit soft, it registers minimally. If you click on the velocity sensitive Preview Pad in S2.0 to listen to an S2.0 instrument, and you like the sound and range of volumes there, but you just aren't getting it to play that way when you hit your drums, then setup your triggers for a nice linear velocity response. If your module is not putting out high velocity values when you hit the drum hard, that is the first thing you want to address. In either case, this was a bit disappointing that this much tweaking had to go into getting S2.0 to work and I hope Toontrack has noted this somehow for future updates. I haven't yet tried any of the templates, but will. I'm sure that could be adjusted as well, but I prefer to play my vdrums. Avoid mouse clicking the 'drums' on your computer or if you have finger pads on a MIDI keyboard because the sensitivity there will blow your speakers.

This is how I got what I consider unity gain when playing along with iTunes. Since I am still messing around with S2.0 in Solo, you can further tweak in the mixer or right click on the suspect pad and adjust that fader in the Instrument section down in the lower right hand corder. I noticed on some pads that at some level it doesn't appear to increase (law of diminishing returns?). You will see a setting called Sensitivity.increase it on each of your pads until you start to get the volume you are looking for. Hit that Trigger button on the module then select F2/Basic. 'I can hear the drums, but they are really quiet.'Ok, so I am not the only one.

Does superior drummer 2.0 work with ableton live lite